Så att en Saturn konsol ska spela brända spel.

För den som vill ha en "ultimat" konsol, eller spela spel utan att behöva en Saturn Kai.

Gör ej konsolen regionsfri. Du behöver också installera vårt andra modchip för det. (behöver du hjälp kan vi installera det åt dig)

Notera att chipet behövs installeras enligt video.

Instruktioner från leverantör:

- For 21pin Saturns, you'll see a row of 3 small solder pads on the back of the chip, using a small blob of solder, bridge the middle pad with the one marked '0014'.  For 20pin Saturns, do not do this and leave each of the 3 jumper pads isolated, no solder joins.

- To power the chip, use a piece of insulated wire to connect the 5V pin on the Saturn's internal power supply to the solder pad on the corner of the mod board that is marked '5V'.

- There are a pair of 20pin ribbon cable sockets and a pair of 21pin sockets.  Remove the ribbon cable from the connector on the CD drive unit, leave the other end. Plug the loose end of the ribbon cable into the apprpriate 20 or 21pin connector marked "MB" on the mod board. Take the extra ribbon cable provided, plug one end into the apprpriate 20 or 21pin "PINCD" connector on the mod board and the other end into the connector on CD Drive unit.

Obviously, check ribbon cables are plugged in the right way round so the pins on the ribbon cable meet the pins on the connector.  Use a piece of card or plastic etc. to insulate the mod board from the metal RF shield, use tape to hold everything in place.

Excellent 20pin video guide: https://www.youtube.com/watch?v=4xHgHW-2eNQ 

21pin: https://www.youtube.com/watch?v=byRadQWLHqE  and https://www.youtube.com/watch?v=GBNDyihBD-w 

For Sanyo drives, these are different, set jumper to 0019 and take power from the trap board

Det finns två modeller av konsoler: 20 pin och 21 pin. 21 pin är vanligast.